隔熱反射節能中間體(新一代 節能產品)

　　III. Heat insulation reflective energy-saving intermediates (a new generation of environmentally friendly energy-saving products)

　　產品介紹:

　　隔熱反射節能中間體是采用 合成樹脂為基料，以功能性的耐熱粉、與陶瓷空心玻璃微球及特種助劑聚合而成，具有紅外反射比和半球發射率的涂料，兩大功效保證了涂料在物體上能降溫，確保了物體內部空間能保持 恒溫的狀態，從而實現節省能耗的目標，達成節能 的效果

　　Product introduction:

　　Heat insulation and reflection energy-saving intermediate is the use of high-quality synthetic resin as the base material, with functional heat-resistant powder, and ceramic hollow glass microspheres and special additives polymerization, with infrared reflection ratio and hemispherical emissivity of the coating, two effects to ensure that the coating on the object can be cooled, to ensure that the object can maintain a lasting constant temperature in the internal space, so as to achieve the goal of saving energy consumption, to achieve the effect of energy saving and environmental protection.

　　產品成分：

　　 水性合成樹脂、耐熱粉、空心玻璃微珠及特種助劑等原材料

　　Product composition:

　　High quality water-based synthetic resin, heat resistant powder, hollow glass beads and special additives and other raw materials.

　　施工條件：

　　基層應堅實，墻面孔洞及墻體空鼓應處理平整、硅酸鈣板、石膏板、模板與墻體之間或板與板的接縫處應先進行接縫處理，表面無浮灰、污物、粉化、起皮(若原墻面基層是批刮過建筑膠水膩子層、石膏粉、紙筋石灰， 全部鏟除干凈)

　　Construction conditions:

　　The substrate should be solid, wall holes and wall drums should be treated smoothly, the joints between calcium silicate board, gypsum board, formwork and wall or board and board should be treated first, the surface should be free of floating ash, dirt, chalking and peeling (if the original wall base is scraped with construction glue putty layer, gypsum powder, paper reinforced lime, all must be eradicated clean).

　　使用范圍：

　　本產品適用于所有的內墻墻體表面

　　Scope of use:

　　This product is suitable for all internal wall surfaces.

　　執行標準：

　　BD/T25261-2018 《建筑用反射隔熱涂料標準》

　　JG134-2010 《夏熱冬冷地區居住建筑節能設計標準》

　　①抗菌 ②反射隔熱 ③ 節能 ④抗堿

　　⑤耐水、防潮 ⑥ ⑦凈味 ⑧速干

　　Implementation standard:

　　BD/T25261-2018 Standard for Reflective Thermal Insulation Coating for Buildings

　　JG134-2010 Energy-saving Design Standard for Residential Buildings in Hot Summer and Cold Winter Areas

　　①Anti-bacterial

　　②Reflective heat insulation

　　③Environmental protection and energy saving

　　④Alkali resistance

　　⑤Water and moisture resistant

　　⑥Anti-mould

　　⑧ Environmental friendly

　　⑧Quick drying

　　產品中心—產品對比：

　　性能分類負離子抗菌防火無機涂料普通乳膠漆

　　成膜物質硅酸鹽、硅溶膠、乳液乳液

　　附著力負離子 與礦物質墻面(含石灰質封面)發生化學結合并可滲入墻面0.5—1mm,形成防酸的硅化石負離子表層機械式表面粘結，粘結力依其中的聚脂粘結物的比率而不同

　　脹縮系數與礦物質墻面的脹縮系數相同，故能避免因受熱而產生的龜裂脹縮系數大于墻壁面的10—20倍，因而極易導致因受熱而產生的涂料龜裂脫落。

　　透水率>400<50

　　抗苔蘚，藻類滋長因強堿性(不含營養)故苔蘚，藻類之微菌不能滋長有機成分助微菌類滋生，造成墻身污化

　　氣味不含有乙二醇、成膜助劑、防腐劑含有乙二醇、成膜助劑、防腐劑

　　靜電對墻身污染的影響不產生靜電，故不會掛灰塵;同時因具可 性，能使墻身內水分迅速蒸發，保持墻身干爽清潔會有靜電產生，容易吸收塵埃，

　　特別是在深層及墻身之龜裂隙隙造成污染

　　涂料壽命比較在一般環境下，

　　其壽命較有機乳膠性涂料長了3—5倍，

　　在極惡劣的天氣或環境下

　　可比乳膠性涂料長5—10倍2—3年后就會出現：

　　生苔蘚，“吐白”，褪色，

　　堆積污物，以至脫落，5年后褪色，2年后受污染嚴重甚至會脫落

　　清潔保養一般墻身的污染物可用高壓水槍來噴射清潔，堅固的則可用細砂紙

　　或一般酸性清潔劑來清洗。( 無機瓷化漆)

　　不能用高壓水槍來清洗

　　(因會導致涂料脫落和剝落等種種問題)

　　 的辦法是重新粉刷

　　防火阻燃可達到 防火，阻燃，不產生有害氣體一般都不阻燃，并產生有害氣體

　　Product Centre - Product Comparison

　　Performance classificationAnionic antibacterial fireproof inorganic coatingsOrdinary emulsion paints

　　Film-forming substancesSilicates, silica sols, emulsionsEmulsions

　　AdhesionThe negative ions are permanently chemically bonded to the mineral wall (with limestone cover) and can penetrate 0.5-1mm into the wall, forming an acid-proof silica negative ion surface layer.Mechanical surface bonding, the bonding force varies according to the ratio of the polyester binder in it.

　　Coefficient of expansion and contractionThe coefficient of expansion and contraction is the same as that of mineral walls, so it prevents cracking due to heat.The coefficient of expansion and contraction is 10-20 times greater than that of the wall surface, which makes it highly susceptible to cracking and peeling of the paint due to heat.

　　Water permeability>400<50

　　Resistance to moss and algae growthNo moss, algae or microflora can grow because of the strong alkalinity (no nutrients)Organic components encourage the growth of microflora and cause staining of the wall.

　　OdourDoes not contain glycols, film-forming agents, preservatives.Contains ethylene glycol, film-forming agents, preservatives.

　　Effect of static electricity on wall contaminationDoes not produce static electricity, so it does not hang dust; at the same time it is breathable, so that the water in the wall evaporates quickly, keeping it dry and clean.Static electricity is generated and dust is easily absorbed, causing contamination especially in the deeper layers and in the cracks of the wall.

　　Comparison of paint lifeUnder normal conditions, it lasts 3-5 times longer than organic latex paints, and 5-10 times longer than latex paints in extremely difficult weather or conditions.After 2-3 years, it will appear: moss, "white", fading, accumulation of dirt and even peeling, after 5 years fading, after 2 years it will be heavily contaminated and even peeling.

　　Cleaning and maintenanceContaminants on the general wall can be cleaned by spraying with a high-pressure water jet, while solids can be cleaned with fine sandpaper or general acidic cleaners. (High-grade inorganic enamelling paint).It cannot be cleaned with a high-pressure water gun (as it will cause problems such as peeling and flaking paint) and the only way is to repaint.

　　Fire retardantIt can achieve class A fire resistance, flame retardant and does not produce harmful gases.They are generally not flame retardant and produce harmful gases.